Product Data Sheet
|
FSC-88 WB Primer/Filler FSC-88 WB is a sprayable, brushable, or rollable waterbased primer/filler that is used to fill and smooth Precision Board prior to finishing with paints and coatings. Use FSC-88 WB when a smooth surface is desired, or as a primer to insure paint adhesion. It dries rapidly and sands easily. FSC-88 WB also works well on wood, concrete, and metal. Prior to using FSC-88 WB, use FSC-360 WB Crack & Repair material to fill large holes, cuts, or any other damage or dings. |
 |
APPLICATIONS:
Brush or Roller - Apply light coat to surface of Precision Board and thoroughly work into surface. Brush or roll out evenly and allow to dry tack free. Usually about 15 minutes. Recoat as soon as surface is tack free. Apply second coast heavier than first coat. Second coat should be applied thick enough to create a creamy surface. See Finishing Methods application instruction sheet. When applying by roller, reduce about 5% with water to reduce roller drag and extend drying time.
Spray - Apply initial coat to all surfaces requiring smooth finish. First coat should be a little lighter than subsequent coats. Do not allow to run. Allow to dry, usually 10 minutes. When tack free apply next coat a little heavier than first coat. If surface has not reached the smoothness desired, wait until tack free and apply next coat. Multiple thin coats are recommended over fewer, thicker coats.
Spray using standard pot, air atomized spray gun with a .020 - .025 spray tip. Pot pressure to be approximately 30 psi - 40 psi. Thin as necessary to desired spraying consistency using water.
Sanding - Sanding of primer can take place as soon as the FSC-88 WB does not ball up on the sandpaper.
Painting - Remember that FSC-88 WB is a primer/filler and must be coated with a suitable exterior paint for exterior applications. After completely dry, it is compatible with all types of paints and finishes, including most lacquers, automotive paints, even gold leafing.
Clean up - Clean up using warm, soapy water. Due to the unusual polymers used in FSC-88 WB, be sure to completely flush all connecting lines and fittings, especially in the spray gun.
NOTE: It is always a good idea to prime and paint both sides of the sign to keep it from being warped by the drying paint. If you have questions regarding the use of FSC-88 WB, please contact Coastal Enterprises Company at (800) 845-0745.
CAUTIONS: Use with adequate ventilation. Avoid prolonged contact with skin and breathing of vapor or spray mist. Close container after each use. Do not take internally. Do not transfer contents to bottles or other unlabeled containers. Harmful or fatal if swallowed, do not induce vomiting. Call physician immediately.
KEEP OUT OF REACH OF CHILDREN.
WARRANTY: All recommendations for product use have been derived from experience and test data believed to be reliable. We warrant and guarantee the uniformity of our products within manufacturing tolerance. However, since the use of our products are beyond our direct control, they are furnished upon the condition that each party shall make his/her own tests to determine their suitability for his/her particular purpose. Except as stated herein, Coastal Enterprises Company makes no warranty or guarantee, expressed or implied, and disclaims all responsibility for results obtained, nor assumes any liability for any damages, whether arising out of negligence or breach of guarantee and is hereby expressly limited to replacement of product only. For additional information on product handling, please refer to FSC-88 WB MSDS.